STRENGTH AND HEAT RESISTANCE

FIL X PETG

Fil X PETG offers easy to print quality parts. PETG's popularity is growing as an alternative to PLA when applications is needed where higer flexability and strength is needed. PETG is also more UV resistant than PLA and will not warp as easily as PLA in the heat of the sun.

PETG Is food safe and can be used for applications where in contact with food.

PLA (Polylactic Acid) is a biodegradable (under the correct conditions) thermoplastic derived from renewable resources such as corn starch or sugarcane. It is one of the most popular bioplastics, used for many applications ranging from plastic cups to medical implants. PLA in its raw form is also FDA and EU commission regulation approved as Food Contact Safe.

CCTREE PLA filament is the new kid on the block, and is rapidly becoming known as the go-to affordable 3D filament in South Africa, which prints reliably and packs a punch when it comes to quality, smooth print finishes. If you are looking for a daily filament which offers great printing results every time without breaking the bank, then CCTREE Filament is the ideal choice for you.

PLA (Polylactic Acid) is a biodegradable thermoplastic which is derived from renewable organic resources such as sugarcane and corn starch.

This makes PLA Filament a surprisingly eco-friendly plastic to print with when compared to other petrochemical based filament options, and the wide range of colours and additives makes it one of the most versatile ranges too.

PLA is by far the most commonly used 3D Printer Filament in the world, partially due to its above-mentioned environmental friendliness, but mostly because it is extremely easy to use and print with as well. PLA is great for beginners who are just getting started, as it has a low shrinkage factor compared to ABS or Nylon, and due to the composition of the plastics, it doesn’t need an enclosure to print large objects - which would typically be prone to warping or layer separation.

A heated bed is not essential, but if used and set to a temperature of around 40° to 70°C, a heated build surface can go a long way in aiding print quality and bed adhesion. Commonly used Bed Adhesion Aids for PLA filament include Blue Painters tape (masking tape), cheap hairspray, Kapton Tape, PEI and BuildTak. PLA’s glass transition temperature (when it starts getting soft and malleable) is around 50°C, and is extruded at temperatures between 190° and 220°C. However, just remember that printing small or detailed parts will require a part cooling fan for optimal results.

TOUGH YET FLEXIBLE

FIL X SBS

Did you know that you are in daily contact with SBS products such as the soles of your shoes or the tyres of your car? But how can SBS be used in FDM 3D printing?

SBS (Styrene-butadiene-styrene) has the unique properties of being both tough and flexible at the same time, thanks to its Polystyrene origin lending it a hard, tough consistency and the Polybutadiene giving it a bit more bounce with its rubbery properties.

This powerhouse combination offers, apart from good layer adhesion, no odour during printing and does not absorb moisture. Furthermore, it has been FDA and EU directive approved for food contact.

Fil X SBS filament is very easy to print with on a glass bed with some hairspray for better bed adhesion and best of all can be smoothed with d-limonene (also available from Fil X!) leaving you with a stunning finished product.